|
|
| |
|
|
|
|
 |
MAGNETIC PUMP |
|
| Features: |
| MATERIAL & FEATURES |
 |
Material: GFR PP, CFR ETFE // |
|
High performance // |
|
All consumable parts are replaceable // |
|
Thread or flange connection // |
|
Magnetic coupling // |
|
Neodymium magnet for 2HP and above |
|
| MODEN |
|
YD-400GS/GSF |
|
YD-401GS/GSF |
|
YD-402GS/GSF |
|
YD-403GS/GSF |
|
YD-405GS/GSF |
|
 |
| FOR THE RESISTANCE OF DRY RUNNING |
| 1. |
Internaionally patented PPS bushing construction: |
| |
a). Radiation of heat for "high heat resistance" |
| |
b). Superior endurance in case of "dry running" |
| |
When most pumps run dry, the friction from the contact points will cause parts, such as the shaft and the bushing, to break down from excess heat. The original anit-heat construction of GS/GSF prevents the pump from a heat deformation because the materials used for the contact point works in lowering the temperature by radiating and insulating heat.
|
| |
 |
|
| 2. |
Air-lock free construction |
| |
When air enters the chamber during operation, it will create an air pocket within a rear casing. However, the unique internal design of our rear casing and the bushing will direct and release the air as well as heat and slurry. |
| |
 |
|
| Ultra Pure Pneumatic Diaphragm Pumps |
|
The original air-releasing construction of the rear casing is useful for the prevention of the "air lock" problem. |
|
Internationally patented PPS bushing construction |
|
Carbon fiber, adopted for the reinforcement of the rear casing, makes the pump strong against burst pressure.
|
|
A selection of the bushings available for the different types of chemicals and the presence of slurry. (Common parts used to minimize stock requirements) |
| |
|
|
Available bushing materials are: carbon, ceramic, PTFE and SiC. |
|
|
For filters |
|
Enhancing the effectiveness of filters |
| |
|
|
For washers |
|
Increasing the washing capability of a spray washer and other various washers |
| |
|
|
For etching |
|
Use of SiC material enables our pumps to be used for cleaning the surface of LCDS |
| |
|
|
For heat exchangers |
|
Ideally balanced to comply with the needs of heat exchangers (compact pump with high performance and reasonable liquid volume) |
| |
|
|
For pumping high specific gravity liquid |
|
Employing a higher magnet torque and a higher horsepower motor enables pumping high specific gravity liquid |
| |
|
|
For liquid transfer to high places
|
|
Max. 140 ft. of head capability for a high rising factory (YD-405GS) |
| |
|
|
 |
| Parts Description: |
|
YD-400~405GS, YD-400~405GSF
|
| |
 |
|
Parts Materials |
| |
 |
|
Specifications: |
| |
 |
|
Performance Curves & Outline Drawing: |
| |
 |
| |
 |
| |
 |
|
|
|
 |
|
| |
|
|
|
|
