Welcome to Harsh Industrial Services

	A-Series
	After 14 years of successful penetration of the market the Series AD was replaced by the A-Series in 1998. All housing parts (non-wetted as well) were now made from the same material. Fluid connections had been integrated into the center housing and were designed to fit flange connections as well. Various connection patterns could be realised by rotating the center housing. Pump versions with either ball or cylinder valves could easily be switched over due to identical inner structures.
	E-Series
	Based on the extensive experience with the predecessor pump series the E-Series is developed in 2009. The result and the name capture the spirit of our vision: E = economic, efficient, ecological.
	Further increased pump safety due to innovative ring-tightening structure.
	Increased capacity.
	Decreased air consumption.
	Reduced noise level.
	Optimized flow pattern.
	Pulsation damper suitable for flnage connection.

MATERIAL & FEATURES

	The ALMATEC pump series BIOCOR is especially designed for sterile applications within the pharmaceutical, biotechnical and food industry. The air-operated diaphragm pumps are EHEDG certificated and ATEX conform according to 94/9/EG directive. BIOCOR pumps with a material combination of PTFE (diaphragms, ball valves, O-rings) equipped with a diaphragm monitoring are 3-A approved. The special design with the integrated cleaning-system enables the CIP (clean in place) and SIP (sterilization in place) capability.
	Always a demand for sterile applications: all housing parts of the BIOCOR pumps show no horizontal areas. Each pump comes with four ball lifting magnets, which can be attached to the pump housing from the outside at the location of the four ball valves. The ball valves are risen up magnetically out of their seats and the pump is drained entirely without having to be dismounted. There are no mechanical ball lifters with parts and seals in the wetted area.
	The two pump sizes B 20 and B 32 achieve max. capacities of 3.5 and 7.5 m³/h resp. a max. discharge pressure up to 7 bar The material for the wetted housing parts is electro polished SS 316 L (1.4435, according to Basel Standard II, ferrite content < 1%) with a surface roughness of < 0.4 µm. The center block is made of polyethylene conductive.

The features of the BIOCOR series at a glance

	air operated pumps for sterile applications within pharmaceutical, biotechnical and food industry
	built in accordance to the essential specifications (EHEDG, 3-A, FDA, Class VI etc.)
	integrated cleaning-system with high cleaning results
	CIP (clean in place) and SIP (sterilization in place) possible
	ATEX conformity
	two pump sizes B 20 und B 32 with max. capacities of 3.5 and 7.5 m³/h
	wetted housing parts made of SS 316 L (1.4435, according to Basel Standard II, ferrite content < 1%) to < 0.4 µm
	sterile design: no horizontal areas
	drainage of the pump by magnetical lifting of the valve balls from the outside
	smooth diaphragm without disc and seals
	diaphragms, ball valves and O-rings made of PTFE or EPDM (FDA conform)
	maintenance-free air control system PERSWING P® without dead spot
	gentle displacement
	no drives, no rotating parts, no shaft seals within the fluid
	easy to start up, step-less control via the air volume and pressure
	proof against dry running
	self priming
	suction and discharge ports suitable for Tri-Clamp and other sanitary threads

Ultra Pure Pneumatic Diaphragm Pumps


A Series	E Series	Biocor

	Ultra Pure Pneumatic Diaphragm Pumps
	A-Series
	E-Series
	Brochure
	Manual